Remote control by the NORTON-COMMANDER Term9X-program
                ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

1. Settings
^^^^^^^^^^^
1.1 term90.exe
^^^^^^^^^^^^^^         

Under "Settings \ Interface":

                    Port: choose the serial port not in use, i.e. COM2.

                    Baud rate: 19200 (recommended)

                    Data bits: 8

                    Parity bit: no

                    Stop bits: 2

                    Data transfer: switch XON/XOFF off and RTS/CTS on 


Under "Settings \ Terminal": the option `ANSI` must be selected.
Under "Settings \": the option `ECHO` must be selected.


1.2 term95.exe
^^^^^^^^^^^^^^

Under "Settings \ Driver": the option `STANDARD` must be selected.

Under "Settings \ Line...": 

                    Port: choose the serial port not in use, i.e. COM2.

                    Baud rate: 19200 (recommended)

                    Data bits: 8

                    Parity bit: no

                    Stop bits: 2

                    Data transfer: switch XON/XOFF off and RTS/CTS on 


Under "Settings \ Terminal": the option `ANSI` must be selected.
Under "Settings \": the option `ECHO` must be selected.



2. Remote control
^^^^^^^^^^^^^^^^^

After all settings have been made, the data transfer can be started.

Press < Space > and < Enter > on the keyboard.
This sets the instrument to remote control mode, indicated on the front panel
by the RM-LED on condition.
From now on, each command can be input by the keyboard, i.e. < vers? >.

Example: 
Activate channel II and simultaneously set the channel II attenuator to 
5mV/div.

Execution:
Input < ch2= >, press and hold  "Alt Gr" key and input the number < 018 >.
After releasing the "Alt Gr" key, the instrument is set. The return code is
displayed after the transmitted command.

The value 0 ("Alt Gr" < 000 >) will not be transmitted.